Tape Out
Aurium has two outputs "bypass" calls TAPE OUT, a Balanced XLR (5) and an unbalanced RCA (6) that
replicate the same signal from the input selected.
Even when Aurium is in standby mode, you can select the input.
connecting the “OUT TAPE” to the input of a remote audio amplifier: when selecting a source in the
Aurium, the signal is then by-passed to the plug TAPE OUT and it is as if it was connected directly to the
sources, even if Aurium is turned off
In this way facilitate the connections without having to rewire the system and being able to use high quality
connections. If you want to listen to your domestic set just switch off on standby Aurium and select the
desired source through Aurium, if you want to listen with headphones you can turn off the main amplifier
and turn Aurium on.
To Next Page
Loading...
