9
Once you have completed the setup then press ‘Send to Device’ and follow the power cycle instruction. You should now close this application, turn
o the power to the Master unit and remove the adapater and USB cable.
Tip: Remember to always download the latest version of the installer tool to ensure you have the most recent version of rmware to install.
You have now completed the initial conguration of the master controller, power cycle the unit and log into your Paxton BLU account
(my.paxton-blu.com), go to Help and select Quick Start Guide to assist you in setting up the controller in your customer and site.
n
Electrical
Voltage 11V DC 24V DC (+20%)
PCB Current (depending on activity) 200 mA
Relay switchable voltage 24V DC (+20%)
Relay switchable current 4A
General purpose outputs OUT-1, OUT-2 0.25 A @ 12V DC
Combined reader port output current 500 mA
Specications
Min Max
To Next Page
Loading...
Need help?
General
