10
The door is hitting the wall when opened.
Door seals installed post install are applying too
much pressure to the latch and deadbolt.
The door rubs against the frame/oor when
opened.
It is important that a door stop is installed to
prevent the handle hitting a wall or object
when the door is opened fully. Failure to do
this can damage the PaxLock Pro when swung
open.
Door seals must be routed into the frame to
prevent excessive force on the latch when the
door is closed. The keep and strike plate may
need to be moved if seals have been tted
without routing.
The door or frame may need shaving down to
ensure smooth operation.
Door Furniture
The through door cables have sheered when
tting the chassis.
There is free play in the handles.
The PaxLock Pro is not responding when I
present a token
This may be because the door is too narrow
for the bolts that have been used. Refer to the
template for the correct bolt and spindles sizes
for each door thickness.
It is important the grub screws on both handles
are fully tightened to remove any free play.
Make sure the secure side chassis is tted. This
is required for the PaxLock Pro to function.
To Previous Page
Loading...
Need help?
General
