To Next PageTo Next Page
Need help?Do you have a question about the Payne PG8MAA048110AAJA and is the answer not in the manual?
Covers installation, combustion, ventilation, ductwork, gas piping, and electrical safety.
Steps to prevent electrostatic discharge damage to electronic components.
Specifies general placement and relation to cooling equipment.
Specifies minimum clearances to combustible materials for safe installation.
Covers requirements for venting and supplying air for combustion.
Instructions for installing the furnace in upflow and downflow configurations.
Guidance for installing the furnace in horizontal orientations.
Warnings and requirements for safe gas piping installation and leak testing.
Warnings about electrical safety during installation and wiring.
Steps for initiating furnace operation and verifying gas flow.
Adjusting gas input rate based on altitude and manifold pressure settings.
Verifying operation of limit switches, draft safeguard, and pressure switches.
Instructions for cleaning or replacing the air filter.
Detailed steps for furnace operation during a heating call.
Using the guide to diagnose and isolate furnace operation problems.
Explains how to read and interpret furnace status codes for diagnostics.
General| Brand | Payne |
|---|---|
| Model | PG8MAA048110AAJA |
| Category | Furnace |
| BTU | 110, 000 |
| AFUE | 80% |
| Input BTU/h | 110, 000 |
| Output BTU/h | 88, 000 |
| Blower Motor Type | Multi-Speed |
| Ignition Type | Hot Surface Ignition |
| Heat Exchanger Material | Aluminized Steel |
| Type | Gas |
| Stages | Single Stage |
