443B101/443B102 19
Manual 19854 Rev. D
ECN 50523
Command: INTU
Purpose: Sets the integration units used (SI or English).
Response: The module responds with a “0” to tell the calling process the command has
been received.
Command String: XYC0ZINTUZ
Description: X—Rack number of the target module (Range: ASCII printable characters, 0
through 3)
Y— Slot number of the target module. (Range: ASCII printable characters, 0
through 7)
C0Z— Module type for the target. Specifying "C01" in this argument addresses
a 443B101, specifying “C02” addresses a 443B102.
INTU— Commands module to set the integration units.
Z— specifies the integration units as follows:
“1” sets integration units to English.
“2” sets integration units to SI
Response String: “0”
Description: This return indicates that the command was received by the card.
Example: Command String: “04C01INTU2”
Response String: “0”
The 443B101 in rack 0 and slot 4 is set use SI units for integration.
To Next Page
Loading...