443B101/443B102 18
Manual 19854 Rev. D
ECN 50523
Command: INTG
Purpose: Engages the internal integration circuitry.
Response: The module responds with a “0” to tell the calling process the command has
been received.
Command String: XYC0ZINTGZ
Description: X—Rack number of the target module (Range: ASCII printable characters, 0
through 3)
Y— Slot number of the target module. (Range: ASCII printable characters, 0
through 7)
C0Z— Module type for the target. Specifying "C01" in this argument addresses
a 443B101, specifying “C02” addresses a 443B102.
INTG— Commands module to engage integration circuitry.
Z— specifies the integrator as follows:
“1” engages single integration down to 1 Hz.
“2” engages single integration down to 10 Hz.
“3” engages double integration down to 1 Hz.
“4” engages double integration down to 10 Hz.
Response String: “0”
Description: This return indicates that the command was received by the card.
Example: Command String: “06C02INTG3”
Response String: “0”
The 443B102 in rack 0 and slot 6 is set to engage double integration circuitry
with low frequency response down to 1 Hz.
To Next Page
Loading...