10
Motherboard User’s Guide
Connect the power connector from the power supply to the ATX1 connector on
the motherboard. J1 is a +12V connector for CPU Vcore power.
If there is a cooling fan installed in the system chassis, connect the cable from the
cooling fan to the CHSFAN1 fan power connector on the motherboard.
Connect the case switches and indicator LEDs to the SW1 header.
Install the Motherboard
Install the motherboard in a system chassis (case). The board is a Micro ATX
size motherboard. You can install this motherboard in an ATX case. Make sure
your case has an I/O cover plate matching the ports on this motherboard.
Install the motherboard in a case. Follow the case manufacturer’s instructions to
use the hardware and internal mounting points on the chassis.
1
SW 1
ATX1
SYSFAN1
1
J1
Pin Signal Pin Signal
1 HD_LED_P(+) 2 FP PWR/SLP( +)
3 HD_LED_N(-) 4 FP PWR/SLP(-)
5 RES ET_ SW_ N( - ) 6 POWER_ SW_P( +)
7 RES ET_ SW_ P( +) 8 POWER_ SW_N( - )
9RSVD_DNU 10KEY
To Next Page
Loading...
