Operaon Systems—Waterway Neo 2100 Series Control, Synergy™ Models
33
SengTemperature
To change water set temperature, use UP and DOWN buons to set the desired temperature. The
screen will display “SET TEMP” with the current set temperature. Aer 5 seconds without any
change to the set temperature, the screen will reverse back to the MAIN screen with current water
temperature display. Changing set temperature will make the heater and pump turn on to get
accurate water temperature and determine if water needs to be heated.
PanelTimeout
It user is in Seng Menus and no buon is pushed within 15 seconds, the screen will meout, current screen seng will be lost and
panel reverts back to MAIN screen.
In MAIN screen, if no buon is pushed within 60 minutes, all LED and LCD lights will turn off and panel goes to sleep. Any buon
pushed in this me will wake the panel up, LED and LCD lights will turn back on and panel will poll for water temperature.
PrimingMode
When power is ON, the system will enter a priming mode with priming screen display on the panel.
In this mode, all devices such as JETS, or LIGHT are operable. JETS can be turned an and off to prime
the pump. System will exit priming mode and go to MAIN display when RETURN buon is pushed, or
aer 4 minutes of inacvity.
SengtheTimeandDate
To set the me press the menu buon. Use the down arrow unl Date‐Time is highlighted then
press menu again. The hour will be highlighted first, use the up or down arrow key to change the
hour to the correct hour. Press the menu key again to highlight the minutes and again, use the
arrow key to change to the correct minute. Press the menu key again to highlight the month, then
use the up or down arrow key to change to the correct month. Press the menu key again to high‐
light the day, then use the up or down arrow key to change to the correct date of the current
month. Press the menu key again to highlight the year, then use the up or down arrow key to
change to the correct year. Press the menu key again to highlight the day of the week, then use the
up or down arrow key to change to the correct day of the week. Once the me and date are
correct, press the return key to return to the menu and, again, to return to the main screen.
SengtheFilterCycle
To set the filter cycle press the menu buon. Use the down arrow unl Filter Cycles is highlighted.
There are 4 programmable filter cycles. A minimum of 8 hours is needed for the ozonator to be
effecve. Use of all 4 filter cycles is not needed but it will allow you greater control of the filter me
each day. Once Filter Cycles is selected in the main menu screen, Filter Cycle 1 is highlighted press
the menu key to enter Filter Cycle 1. The start me hour will be highlighted use the up or down
arrow key to adjust to the desired hour. Press the menu key again to move to minutes, again, use
the up or down arrow key to adjust to the desired minute. Press the menu key again to move to
am/pm use the up or down arrow key to select the desired selecon. Press the menu key again to
set the number of hours of duraon using the up or down arrow keys. The duraon is the amount
of hours the spa will filter during Filter Cycle 1. Press the menu key again to set the minutes of dura‐
on using the up or down arrow keys. Press the return key to return to the filter cycles menu. If
desired, repeat above direcons to program more filter cycles. When finished, press return to go
back to the menu and return again to go back to the main screen.
Date‐Time
12:34pm
3/25/16
Friday
FilterCycle1
StartTime:
12:00am
Duraon:
7:00
To Next Page
Loading...
Need help?
General
