PDC spas SYNERGY Series FX15 User Manual

Operaon Systems— Waterway Neo 2100 Series Control, TruSwim® Models
40
ErrorCodes
Error caused when SENSOR 1 and
SENSOR 2 have been plugged in
incorrectly. Swap the SENSOR 1
and SENSOR 2 plug in controller to
correct this problem.
Clean filter.
Check SENSOR 1 connecon.
Clean filter, check jets in “on”
posion and valve open.
Error caused by no water flow through
heater or no water in heater.
Check to be sure there is enough
water flow through heater.
Clean filter.
Check SENSOR 1 connecon
or replace SENSOR 1.
Clean filter, check jets in “on”
posion and valve open.
Check to be sure there is enough water
flow through heater.
Wait for water temperature to cool down.
Wait for water temperature to cool down.
Check to be sure there is enough water
flow through heater.
Error caused when SENSOR 1,2, or 3
detects low temperature. All JETS and
BLOWERS will turn on automacally to
protect plumbing from freezing. JETS and
BLOWERS will shut down when all 3
SENSORS reach a desired temperature.
Clean filter.
Check SENSOR 2 connecon.
Clean filter, check jets in “on”
posion and valve open.
Check SENSOR 2 connecon
or replace SENSOR 2.
Clean filter.
Check SENSOR 3 connecon.
Check SENSOR 3
connecon or
replace SENSOR 3.

PDC spas SYNERGY Series FX15 Specifications

General

Brand	PDC spas
Model	SYNERGY Series FX15
Category	Hot Tub
Language	English