EasyManua.ls Logo

Peak PKC0AZ - User Manual

Peak PKC0AZ
8 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
900 Peak Amp
Jump-Starter
Model No.: PKC0AZ
Owner’s Manual
and Warranty Information
Read these instructions completely before using this product.
Retain this Owner’s Manual for future reference.
3/14
1
© 2014
900 Amperios Pico
Jump-Starter
No. de Modelo: PKC0AZ
Manual del Propietario
e Información de Garantía
Lea completamente estas instrucciones antes de usar este producto.
Conserve este Manual del Propietario para referencia futura.
1
3/14© 2014

Table of Contents

Questions and Answers

  • M
    Molly McdowellJul 26, 2025
    What to do if my Peak PKC0AZ doesn't start my vehicle?
    • D
      Diane DavisJul 26, 2025
      If your Peak Remote Starter fails to start your vehicle, several factors could be at play. First, ensure proper cable clamp connections by rotating the cable clamps back and forth to establish a solid connection. If the vehicle battery charge is very low, allow 3 to 4 minutes before attempting another start. Also, make sure that the Jump-Starter has sufficient charge, and fully recharge it if necessary. In some cases, the vehicle battery itself may be defective and require replacement.
  • V
    Valerie WilliamsAug 11, 2025
    Why is my accessory not working with the Peak Remote Starter's 12-volt DC power socket or USB power outlet?
    • M
      Marilyn BellAug 11, 2025
      If an accessory device connected to the 12-volt DC power socket or USB power outlet isn't working with your Peak Remote Starter, there are a few potential reasons. First, verify that the 12V DC Power & USB ON/OFF switch is activated. A poor connection at the 12-volt DC power socket could also be the cause, so try reinserting the accessory plug. Lastly, ensure that the Jump-Starter has sufficient battery charge by fully recharging it.

Summary

Introduction

Safety Precautions

Battery Jump-Starting Safety

Safety guidelines for jump-starting vehicles using lead-acid batteries.

Jump-Starter Safety

General safety instructions and warnings for using the jump-starter unit.

Features

Operation

Checking Jump-Starter Battery Status

How to check the battery charge level of the jump-starter unit.

Low Charge Alert (LCA)

Explanation of the Low Charge Alert system and its audible alarm.

Charging Jump-Starter Battery

Instructions on how to charge the jump-starter battery using AC power.

Jump-Starting (Negative Ground Systems Only)

Step-by-step guide for jump-starting a vehicle, focusing on negative ground systems.

DC Power Socket Operation

How to use the 12-volt DC power socket for accessories.

USB Power Outlet Operation

Instructions for using the USB power outlet to charge devices.

Worklight Operation

How to operate the built-in worklight of the jump-starter.

Troubleshooting

Care and Maintenance

Storage

Proper methods for storing the jump-starter unit when not in use.

Battery Replacement; Disposal

Information on battery recycling and proper disposal of the unit.

Specifications

FCC Information

Limited Warranty

To Obtain Service

Instructions on how to contact customer service for warranty claims.

Peak PKC0AZ Specifications

General IconGeneral
BrandPeak
ModelPKC0AZ
CategoryRemote Starter
LanguageEnglish

Related product manuals