EasyManua.ls Logo

Peak PKC0C1500 - User Manual

Peak PKC0C1500
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Cargador de Baterías/
Mantenedor de 1.500 mA
No. de Modelo: PKC0C1500
Manual del Propietario
e Información de Garantía
Lea completamente estas instrucciones antes de usar este producto.
Conserve este Manual del Propietario para referencia futura.
12/16
© 2016
1
1500mA Battery
Charger/Maintainer
Model No.: PKC0C1500
Owners Manual
and Warranty Information
Read these instructions completely before using this product.
Retain this Owners Manual for future reference.
1
12/16
© 2016

Questions and Answers

  • S
    Sarah SmithAug 2, 2025
    What to do if no LED lights turn on on my Peak PKC0C1500 Battery Charger?
    • J
      Justin BoydAug 2, 2025
      If no LED lights are illuminated on your Peak Battery Charger, ensure the charger is properly connected to a working 110/120 volt AC grounded power outlet.
  • E
    Erik GonzalezAug 6, 2025
    How to fix loose charging cable connections on my Peak PKC0C1500?
    • B
      Brooke BartonAug 7, 2025
      If you find loose charging cable connections on the battery, unplug the Peak Battery Charger and inspect the battery connections. Ensure there's a secure connection at the battery terminals and/or the vehicle's chassis.
  • J
    jonathan05Aug 12, 2025
    What to do if my Peak PKC0C1500 Battery Charger shuts off due to a short circuit?
    • G
      Gary SanchezAug 13, 2025
      If your Peak Battery Charger shuts off due to a short circuit, disconnect the charging clamp cables and check them for shorts. Also, inspect the battery for a short. Once the short circuit condition is resolved, charging will resume.
  • R
    Rachel AustinAug 17, 2025
    Why won't the green 'Battery Charged' LED light up on my Peak Battery Charger after charging?
    • T
      tmontoyaAug 17, 2025
      The green 'Battery Charged' LED might not illuminate for a few reasons: * The battery might need more time to fully charge. Ensure it has been allowed sufficient charging time. * The battery could be too cold. The charging rate will increase as the battery warms above 32 °F (0 °C).
  • L
    loganrobertsonAug 22, 2025
    What to do if the red reverse polarity LED is flashing on my Peak PKC0C1500 Battery Charger?
    • T
      Taylor WilsonAug 22, 2025
      If the red reverse polarity LED is flashing, unplug the Peak Battery Charger and check that the charger cables are correctly connected. Refer to pages 8 and 9 for instructions on proper cable connection to the battery.
  • P
    Phillip MathisAug 27, 2025
    What to do if the battery voltage is low on my Peak PKC0C1500?
    • F
      fhatfieldAug 27, 2025
      If the battery voltage is low or the battery is damaged, verify the battery voltage using a multimeter. Replace the battery if the voltage is too low.

Summary

Safety Precautions

Important Safety Instructions

This manual contains important safety and operating instructions for the battery charger model PKC0C1500.

Cancer and Reproductive Harm Warning

The battery clamp component contains DEHP, a chemical linked to cancer and reproductive harm in California.

General Hazard Warning

All safety messages with WARNING level hazards require compliance to avoid death or serious injury.

Introduction

Product Overview

The CHARGE CARDTM 1500mA Battery Charger/Maintainer is a fully automatic 6V/12V charger intended for long-term maintenance-free charging.

Charging Modes

The charger features three modes: Bulk, Absorption/Constant Voltage, and Float/Maintenance.

Features

LED Indicators

Includes Charge Indicator, Reverse Polarity, 12-Volt Mode, and 6-Volt Mode indicator lights.

Mode Selection

A dedicated button allows selection between 6-volt or 12-volt charging modes.

Battery Compatibility

Charges 6V or 12V lead-acid batteries (AGM, gel-cell, deep-cycle) and includes O-ring cables.

Specifications

Electrical Ratings

Input: 120V 60 Hz 0.6A; Charging voltage: 6V/12V DC; Charging current: 1.5A.

Physical Dimensions

Height: 2-3/4 in., Width: 4-3/8 in., Depth: 1-3/8 in., Weight: 0.77 lb.

Operating Instructions

LED Display Panel

Explains the function of the green Charge LED and red Reverse Polarity LED.

Charging Procedure

Details on before charging, pre-charge activation, and charging with battery in or out of vehicle.

Connecting Charger

Step-by-step guide for connecting the charger clamps to the battery terminals or vehicle chassis.

Charging Times

Provides estimates for charging time based on battery capacity (Ah) and charger rate.

Care and Maintenance

Fuse Replacement

Instructions for safely replacing the 7.5A fuse in the charger.

Cleaning

Guidance on cleaning the charger's exterior case and charging cables/connectors.

Adding Water to Battery

Safety precautions and procedure for adding distilled water to battery cells.

Storage Guidelines

Recommendations for storing the charger and batteries properly to prevent damage.

Troubleshooting

No LEDs Lit

Action steps if the charger's LEDs do not illuminate, checking power source and connections.

Charging Issues

Troubleshooting steps for slow charging, low battery voltage, or short circuits.

Reverse Polarity LED

Guidance when the red reverse polarity LED is flashing, indicating incorrect connections.

Limited Warranty

Warranty Coverage

One-year warranty against defects in material and workmanship for the battery charger.

Obtaining Service

Procedure for returning the product for warranty service, including contact information.

Peak PKC0C1500 Specifications

General IconGeneral
Output Voltage12V DC
Output Current1.5A
TypeAutomatic Battery Charger
Charging TimeVaries by battery capacity
Charging PortAlligator Clips
Safety FeaturesReverse Polarity Protection, Overcharge Protection, Short Circuit Protection

Related product manuals