PeakTech 1220 - Page 107

7.10. Setting the Cursor Measurements
This oscilloscope allows you to make manual cursor measurements on time and voltage.
7.10.1 Setting the cursor measurement in normal mode
The cursor measurement menus are listed and described in the following table.
Function menus
Settings
Description
Type
OFF
Close the cursor measurement.
Voltage
Display the voltage measurement cursor and menu.
Time
Display the time measurement cursor and menu.
Delta
Display the difference of measured value between the two
channels.
Cur1
Display the relating measured value of Cursor 1.
Cur2
Display the relating measured value of Cursor 2.
To make a voltage measurement, doing the following:
1.) Press the MENU key and the function menus are displayed at the right of the screen.
2.) Press the MENU ▲ or MENU ▼ key to select CURS MEAS. Four options are shown at the bottom of the screen.
3.) Press F1 key to select the measurement type Voltage. Two purple crossing dashed lines V1 and V2 are shown on
the screen.
4.) Press OPTION and display as
◄/► – Cursor 1
▲/▼ – Cursor 2
When setting OPTION▲ or OPTION▼, V2 will move up and down and the relating voltage value to the zero position of
the Channel will show at the bottom of the screen. Setting OPTION ◄ or OPTION ►, V1 will move up and down and the
relating voltage value to the zero position of Channel 1 will show at the bottom of the screen, at the same time the
increment shows the absolute value of V1-V2 shown as Fig 45:
Figure 45: Use the Cursor for a Voltage Measurement
-106-