When log out submenu, every value will show on the right bottom of the screen as figure 46:
Figure 46
To use the cursor for a time measurement, do the following:
1.) Press the MENU key and the function menus are displayed at the right of the screen.
2.) Press the MENU ▲ or MENU ▼ key to select CURS MEAS
3.) Press the F1 key to the measurement type Time. Two vertical dashed lines T1 and T2 appear on the screen.
4.) Press OPTION and display as
◄/► – Cursor 1
▲/▼ – Cursor 2
Press ▲(OPTION) or ▼(OPTION) and see T1 move left and right and LCD display the time value match T1 to
point position in panel; press ◄ (OPTION) or ► (OPTION) and see T2 move left and right and LCD display the
time value match T2 to point position in panel.
Now, you can see a screen that looks like the following figure 47.
Figure 47: Use the Cursor for a Time Measurement
-107-
To Next Page
Loading...
