PeakTech 1220 - Page 109

When log out submenu, every value will show on the right bottom of the screen as figure 48:
Figure 48: Use the Cursor for a Time Measurement
7.10.2 Setting the cursor measurement in FFT mode
FFT being on, the cursor measurement menus are listed and described in the following table.
Function menus
Settings
Description
Type
OFF
Range
Frequency
Close the cursor measurement.
Display the Vamp measurement cursor and menu.
Display the freq measurement cursor and menu.
Delta
Display the difference of measured value between the two
Cursors
Curs1
Display the relating measured value of Cursor 1
Curs2
Display the relating measured value of Cursor 2
To make a range measurement on CH1, doing the following:
1.) Press the MENU key and the function menus are displayed at the right of the screen.
2.) Press the MENU ▲ or MENU ▼ key to select CURS MEAS. Five options are shown at the bottom of the screen.
3.) Press F1 key to select the measurement type Range. Two purple crossing dashed lines V1 and V2 are shown on
the screen.
4.) Press OPTION and display as
◄/► – Cursor 1
▲/▼ – Cursor 2
Press ▲ (OPTION) or ▼ (OPTION) to see V1 move up and down and the panel will display the voltage value
match V1 and Channel 1 Zero; Press ◄ (OPTION) or ► (OPTION) to see V2 move up and down and panel will
display the voltage value match V2 to Channel 1 Zero. LCD panel also display the absolute value of V1-V2.
Now, you can see a screen that looks like the following figure 50.
Figure 49: Cursor range measurement
-108-