PeakTech 1220 - Page 111

7.12. Record of waveforms
Waveform record: The function provides you to set the time interval between the frames and record the waveform up to
1000 numbers and get the better analysis effect more than before through Playback and Save functions.
Four record modes: Record, Play back, Storage, OFF.
Record：Record the waveforms up until the set number of frames at specified time intervals.
Record-Menu:
Menu
Setting
Instruction
Mode
Record
Select record mode.
Play back
Select play back mode.
Storage
Select storage mode.
OFF
Turn off all recorder functions.
End frame
1-1000
Set number of record frames.
Operate
Play
Press to start recording.
Stop
Press to stop recording.
Interval
1 ms – 1000s
Set time interval between record frames.
To next menu
Refreshed
ON
The waveforms are in the state of refreshing when recording.
OFF
The waveforms stop refreshing when recording.
Direction
Increase
The value increases from that of end frame to time interval
Decrease
The value decreases from that of end frame to time interval
Back to previous menu.
Play back:
Play back the recorded waveforms.
Play back-Menu:
Menu
Setting
Instruction
Play mode
Loop
Set repeat play mode.
Single
Set single time play mode.
Operate
Play
Press to start playback.
Stop
Press to stop playing.
Interval
1ms-20s
Set up interval value between frames.
To next menu
Start Frame
1-1000
Set start frame.
Cur frame
1-1000
Select current frame to be played.
End frame
1-1000
Set End frame.
Direction
Increase
The value increases at the mode of setting start frame, cur frame and
end frame
Decrease
The value decreases at the mode of setting start frame, cur frame and
end frame
Back to previous menu (Only when Sync is set as Line NUM).
-110-