PeakTech 1220 - Page 112

Storage:
Store recorded waveforms in non-volatile memory according to the setup frames.
Storage-Menu:
Menu
Setting
Instruction
Start Frame
1-1000
Set first frame to be saved
End frame
1-1000
Set last frame to be saved.
Direction
Increase
The value increases from the set start frame to the end frame
Decrease
The value decreases from the set start frame to the end frame
To next menu
Save
Save recorded waveform to internal memory location.
Load
Recall recorded waveform from internal memory location.
Back to previous menu.
Record the waveform as follows:
1.) Press the MENU key and the function menu appears at the right of the screen.
2.) Press the MENU ▲ or MENU ▼ key to select RECORD and five options are displayed at the bottom of the
screen.
3.) Press the F1 key to select the Record mode.
4.) Press F2 and set the End frame at 300 (select the direction as Increase or Decrease in the second menu before
step4).
5.) Press F4 and set the time Interval to 1.00ms.
6.) Press F5 to enter into the second menu.
7.) Press F1 and select OFF to stop refreshing waveforms.
8.) Press F5 to back up to the first menu.
9.) Press F3 and select Play to operate.
Fig 51: the first page of the record Fig 52: the second page of the record
-111-