36
1.4 Preparing the device
Use only the type of test leads supplied with your meter. These
test leads are rated for 1000 Volts.
Warning!
* If you try to measure DC voltages above 1000 V or AC voltages
above 750 V AC, you might damage your meter and expose
yourself to a serious shock hazard. Use extreme care when you
measure high voltages.
* Never connect the test lead plug into the COM terminal to a
source of voltage greater than 500 Volts with respect to earth
ground. This creates a serious shock hazard.
To Next Page
Loading...
Need help?
General
