Need help?Do you have a question about the PeakTech 2705 and is the answer not in the manual?
General| Display | LCD, 3 1/2 digits |
|---|---|
| DC Current | 200 μA / 2 mA / 20 mA / 200 mA / 10 A |
| Battery Test | 1.5V, 9V |
| DC Voltage | 200mV/2V/20V/200V |
| DC Voltage Accuracy | ±0.5% of reading + 1 digit |
| AC Voltage | 200V |
| DC Current Accuracy | ± 1.0% + 2 dgt. |
| Resistance | 200 Ω / 2 kΩ / 20 kΩ / 200 kΩ / 2 MΩ |
| Continuity | Yes, with buzzer |
| Diode Test | Test current 1 mA |
| Category | CAT III 600 V |
| Power Supply | 9V battery (6F22) |
| Capacitance Range | No |
| Frequency Range | No |
Covers safety directives, overvoltage categories, and essential operational safety rules for the instrument.
Specific instructions on instrument usage, handling, environmental considerations, and avoiding electrical hazards.
Step-by-step guide for performing DC and AC voltage measurements.
Instructions for measuring DC and AC current, including range selection and connection.
Procedure for measuring resistance, including safety warnings and audible signal indication.
Steps for performing a continuity check, including the audible signal for low resistance.
Procedure for testing diodes, including polarity reversal and interpretation of readings.
Detailed steps for performing low resistance measurements, including range selection and calibration.
To Next Page
