56
7.1 Installing the battery
Your meter requires a 4 x 1,5 V batteries (AA, UM-3) for power.
The battery symbol appears when the batteries voltage drops to
certain limits. For correct operation, replace the battery as soon
as possible. Continued use with a low battery will lead to errors in
reading.
Warning!
To avoid electric shock, disconnect both leads from any
equipment before you remove or install the batteries.
Follow these steps to install the batteries.
1. Turn off the power and disconnect the two test leads.
2. Remove the 2 screws to open the battery compartment.
3. Place the batteries inside and snap it onto place.
Warning!
Do not discard the provided battery insulation capsule. If you do
not use this insulation capsule properly, it can damage the meter
or cause bodily injury.
4. Place the battery compartment cover and tighten screws.
Warning!
Do not operate the meter until you replace the battery and close
the battery compartment cover.
Caution!
Batteries, which are used up, dispose duly. Used up batteries are
hazardous and must be given in the for this being supposed
collective container.
To Next Page
Loading...
Need help?
General
