Need help?Do you have a question about the Peavey 210 TX and is the answer not in the manual?
Connect line level signal to power amplifier input.
Connect line level signal to additional power amplifier (daisy chain).
Controls the volume level of the enclosure.
Safety feature for the 3-wire line (mains) cable with proper grounding.
Center position is "OFF." Two "ON" positions provided.
Replace fuse with same type/value; disconnect power before replacement.
Illuminates when AC power is being supplied to the amp.
Connection for external speaker cabinet, minimum total impedance 2 ohms.
Prevent electrical shock/fire hazard, avoid rain/moisture, and do not remove cover.
Rated power and typical power output at clipping for various impedances.
Frequency response range at specified power and load.
Total Harmonic Distortion (THD) and Intermodulation Distortion (IMD) levels.
DDT dynamic range and maximum total harmonic distortion with overload.
Hum & noise levels, input sensitivity, and input impedance.
Domestic power consumption rating for the unit.
DANGER: Exposure to high noise levels can cause permanent hearing loss.
General cautions regarding safety, ventilation, heat, water, and servicing.
To Next Page
General
