Need help?Do you have a question about the Peavey EuroSys 15PM and is the answer not in the manual?
This document provides operating instructions for the EuroSys 15PM powered monitor enclosure.
Connects line level signals from the mixer; two sockets for daisy chaining.
Slider controls the level or volume of the enclosure.
Four sliders adjust frequencies +/- 12dB for feedback control.
Illuminates when AC mains power is supplied.
Connects a further unpowered monitor with 8 ohms impedance.
Used to turn the Eurosys 15PM ON or OFF.
IEC 320 combined mains connector and fuse holder with supplied cord.
Instructions for wiring mains lead colours to plug terminals.
Specifies output power: 105 Watts into 8 ohms, 150 Watts into 4 ohms.
Specifies input sensitivity: 0.7 volt for 105 Watts into 8 ohms.
Specifies fuse rating: 1.6 ampere anti surge.
Specifies power consumption: 325 Watts at 150 Watts output.
Specifies mains voltage: 230 Volts AC (only) 50/60 Hz.
To Next Page
General
