Need help?Do you have a question about the Peavey HDH 244T and is the answer not in the manual?
Details about the HDH™ 244T trapezoidal enclosure.
Frequency response from 55 Hz to 18 kHz measured at 1 meter.
The -3 dB low frequency point of the enclosure.
The -10 dB usable low frequency point of the enclosure.
Continuous and program power handling specifications.
SPL measurement at 1 meter with 1 watt input.
Maximum SPL achievable with music.
Horizontal and vertical radiation angles at -6 dB points.
Q factor for directivity at 500 Hz - 16 kHz median.
Di for directivity at 500 Hz - 16 kHz median.
Details the woofer and compression driver used.
The tuning frequency of the enclosure's vented design.
The crossover frequency between drivers.
Specifies the type of crossover used.
Slope of the electrical crossover for high and low pass.
Nominal impedance of the loudspeaker system.
Minimum impedance of the loudspeaker system.
Description of the input connectors for full-range and bi-amp.
Details on plywood construction and carpet finish.
Information on flying points for suspension.
The total weight of the loudspeaker system.
Explains the meaning and measurement of frequency response.
Explains beamwidth and directivity factors for placement.
Details Peavey's power handling rating methodology.
Caution about potential permanent hearing damage.
Warning regarding structural engineer consultation for suspension.
Operating bandwidth from 55 Hz to 18 kHz.
Output level (100 dB) and nominal impedance (8 ohms).
Continuous power handling and minimum amplifier headroom.
Nominal radiation geometry in horizontal and vertical planes.
Outside dimensions and weight of the loudspeaker.
Information on obtaining warranty statement details.
Details on suspension safety, weight limits, and angles.
Caution about permanent hearing damage from loudness.
To Next Page
General
