Peavey Audition 110

SPECIFICATIONS
POWER AMP
Rated Power 81 Load:
25 W RMS into 8 ohms
Power @ Clipping: (typically)
(5% THD, 1 kHz, 120 V AC line)
25 W RMS into 8 ohms
Total Harmonic Distortion:
Less than 0.5%, 100 mW to IO W RMS, 60 Hz to
10 kHz, 4 ohms (typically below 0.2%)
Power Consumption:
Domestic: 50 W, 60 Hz, 120 V AC
Export: 50 W, 50/60 Hz, 220-230/240 V AC
Dimensions and Weight:
16.125” H x 18.125” W x 9.25” D
19.6 Ibs.
PREAMP
The following specs are measured @ 2 kHz with the controls
preset as follows:
Channel Select Normal (out)
Low& High @ 10
Mid @ 0
Pre Gain 6: Post Gain @ 10
Reverb 63 0
Nominal Levels are with Normal Gain @ 5
Minimum Levels are with Normal Gain @ 10
Preamp Input:
(normal channel)
Impedance: High-Z, 1 M ohm
Nominal Input Level:
-6 dBV, 500 mV RMS
Minimum Input Level:
-23 dBV, 70 mV RMS
Maximum Input Level: 0 dBV, 1 V RMS
CD/Tape Input:
Input Impedance: 100 K ohms
Nominal Input Level: 0.5 V RMS, -6 dBV
(Stereo jack designed for use with stereo headphone outputs on
CD/Tape players)
Headphone Output:
Load Impedance: 4 ohms or greater
Nominal Power Output: 20 mW into 4 ohms
(Stereo jack, monaural signal, disconnects internal speaker when
phone plug is inserted)
System Hum & Noise
@ Nominal Input Level:
(20 Hz to 20 kHz unweighted)
62 dB below rated power
Equalization:
Special low, mid, & high passive type EQ
and
Due to our efforts for constant improvements,
specijicatiom listed herein are subject to change
without
5