7
Audition
®
- Guitar Amplifier
Before you begin to play through your amplifier, it is very important to ensure the
product has the proper AC line voltage supplied. You can find the proper voltage for
your amp printed next to the IEC line (power) cord on the rear panel of the unit. Each
product feature is numbered. Refer to the front panel diagram in this manual to locate
the particular features next to their number.
INPUT JACK
Use this 1/4” jack to connect your guitar. Connect your guitar prior to turning power on to the amplifier.
VOLUME
This control sets the overall level of the Audition.
LEAD ON/OFF
In the OFF position‚ the Audition will produce a nice clean sound. Once engaged‚ look out‚ this little
amplifier will rock.
HIGH EQ
This control allows you to dial in the amount of high-end tone for your guitar.
LOW EQ
This control adds low-end-tone to your sound. Use to fatten up the sound of your guitar.
HEADPHONE OUTPUT
This standard 1/4” output jack allows you to connect standard headphones to the Audition.
When headphones are connected to the Audition‚ the speaker is automatically turned off.
POWER LED
This LED illuminates when power is supplied to the Audition.
POWER SWITCH
This two-way rocker switch applies power to the unit when placed in the ON position.
ENGLISH
1
2 3 4
5 6 7
8
1
2
3
4
5
6
7
8
Rated Power:
7 W(rms) into 8 Ω
Dimensions (H x W x D):
9.5" x 9.7" x 5.4"
24.1 cm x 24.6 cm x 13.7 cm
Weight:
6.4 lbs.
2.9 kg
Specifications
6
To Next Page
Loading...
Need help?
General
