Need help?Do you have a question about the Peavey GPS 1500 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| Power Output (8 Ohms) | 300W |
| THD | <0.1% |
| Signal-to-Noise Ratio | >100dB |
| Input Impedance | 20k ohms |
| Inputs | XLR |
| Outputs | Binding posts |
| Protection | Short circuit, DC voltage, thermal overload |
| Dimensions | 19" |
U.S. Government's OSHA specified permissible noise level exposures with duration.
Comparison chart of GPS Series amplifier specifications across different models.
Instructions for inspecting the amplifier upon unpacking and registering the product for warranty.
Guidance on rack mounting the GPS Series amplifiers in a standard 19-inch rack.
Description of AC power cord, switch, and power LED indicators on the amplifier.
How to select between stereo and bridged mono operation modes via the Mode Switch.
Details on combination input connectors (XLR/1/4") for Channel A and B.
Explanation of the recessed Input Polarity switch for phase selection on XLR inputs.
Description of the Thru jacks for flexible signal patching and linking amplifier inputs.
Details on 1/4" output jacks and binding posts for GPS 900/1500 models.
Details on Speakon® connectors for GPS models other than 900/1500.
Information on five-way binding post speaker outputs and their usage.
Explanation of DDT and Signal LEDs indicating compression, clipping, or signal presence.
Description of the input gain control for adjusting signal level and system headroom.
Information on the variable-speed DC fans for amplifier cooling.
Guidance on AC mains voltage and circuit breaker requirements for amplifier operation.
Details on air intake and exhaust for proper cooling, especially in rack-mounted setups.
Instructions for setting up stereo or bridged mono operation and signal routing.
Explanation of DDT compression for protecting speakers from clipping and square waves.
Description of LFC™ circuit for handling abnormal loads and preventing damage.
Information on thermal protection that disconnects the load if the unit overheats.
Diagram and notes for connecting GPS 900/1500 models in stereo mode.
Diagram and notes for connecting other GPS models in stereo mode.
Diagram and notes for connecting GPS 900/1500 models in bridged mono mode.
Diagram and notes for connecting other GPS models in bridged mono mode.
Information on what the Peavey warranty covers and does not cover for products.
Procedure for getting warranty service from an Authorized Peavey Dealer or Service Center.
Details on limitations of implied warranties and exclusions of damages.
To Next Page
