Need help?Do you have a question about the Peavey GPS 2600 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| 4 Ohms Per Channel | 900W |
| 2 Ohms Per Channel | 1300W |
| 8 Ohms Bridged | 1800W |
| 4 Ohms Bridged | 2600W |
| Input Sensitivity | 1.4V |
| Signal to Noise Ratio | > 100 dB |
| Damping Factor | > 300 |
| Frequency Response | 20Hz - 20kHz |
| Cooling | Fan |
| Dimensions | 19" x 3.5" x 15.5" (483mm x 89mm x 394mm) |
| Input Impedance | 20k Ohms |
Guides for inspecting the unit, installing it, and performing basic setup procedures.
Details on the amplifier's AC power cord, switch, and indicator LED.
Information on selecting stereo/bridged mode and using input connectors like XLR and 1/4".
Explanation of the input polarity switch and the function of the 'Thru' output jacks.
Details on connecting speakers using Speakon connectors and binding posts.
Overview of DDT/Signal LEDs and the Input Gain controls for each channel.
Information regarding the amplifier's cooling fans and their speed control.
Guidance on AC power requirements, circuit sizing, and proper ventilation for cooling.
Instructions for configuring signal routing for stereo or bridged mono operation.
Details on DDT, Load Fault Correction, Initialization, Thermal, Short Circuit, and DC Voltage protection.
Details on warranty coverage, duration, and procedures for obtaining service.
Information on limitations of implied warranties and exclusions of damages.
To Next Page
