Need help?Do you have a question about the Peavey GPS 900 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Signal to Noise Ratio | > 100 dB |
| THD | < 0.1% |
| Damping Factor | > 200 |
| Input Sensitivity | 0.775V |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 20 kOhms |
| Weight | 25 lbs |
| Power (2 ohms, stereo) | 900 Watts |
| Power (4 ohms, stereo) | 600 Watts |
| Dimensions | 19" x 3.5" x 12.5" (483 x 89 x 318 mm) |
Essential safety guidelines for operating the amplifier safely and preventing hazards.
Technical specifications for the GPS Series amplifiers, including power and performance.
Procedures for unpacking, inspecting, and registering the amplifier.
Steps for physically installing the amplifier in a rack.
Basic steps for initial setup and operation of the amplifier.
Information on AC power connections, switch, and LED indicators.
Details on XLR and 1/4" input connectors and their properties.
How to use the mode switch to select stereo or bridged mono operation.
Specifics of the Channel A combination input connector.
Explanation of the input polarity switch and its effect on phase.
Using the Thru jack for signal patching and distribution.
Details on connecting speakers using Speakon connectors.
Using the five-way binding post speaker outputs.
Adjusting the input gain for each channel.
Explanation of DDT and Signal LEDs for channel status.
Explanation of Power LEDs and other system indicators.
Description of the fan grill and cooling system operation.
Information on AC mains voltage and circuit breaker requirements.
Guidance on ensuring adequate airflow for proper amplifier cooling.
How to connect inputs and configure stereo or bridged mode operation.
Details on amplifier protection circuits like DDT, LFC, Thermal, and DC voltage.
Diagram and instructions for connecting the amplifier in stereo mode.
Diagram and instructions for connecting the amplifier in bridged mono mode.
Chart for selecting appropriate speaker wire gauge based on length and impedance.
Detailed technical specifications for the Peavey GPS 900 amplifier model.
Detailed technical specifications for the Peavey GPS 1500 amplifier model.
Detailed technical specifications for the Peavey GPS 2600 amplifier model.
Detailed technical specifications for the Peavey GPS 3400 amplifier model.
Detailed technical specifications for the Peavey GPS 3500 amplifier model.
Details on what the warranty covers, exclusions, and how to obtain service.
To Next Page
