Need help?Do you have a question about the Peavey CS 800 and is the answer not in the manual?
General| Power Output | 400W per channel @ 4 ohms |
|---|---|
| Power (Stereo) | 400W @ 4 Ohms |
| Power (Bridged) | 800W @ 8 Ohms |
| Frequency Response | 20 Hz to 20 kHz |
| Signal to Noise Ratio | Greater than 100 dB |
| Input Impedance | 10k ohms |
| Dimensions | 19" W x 12.5" D |
| Total Harmonic Distortion | Less than 0.1% |
Indicators for DDT compression status and power operational status, including fault detection.
Controls for adjusting input gain and turning the amplifier on/off.
Parallel ¼" jacks for quasi-balanced input, also usable as line out.
XLR input and switch for transformer-balanced or quasi-balanced operation.
Parallel jacks and binding posts for speaker connection.
Parallel ¼" input jacks for Channel B, with switching type functionality.
XLR input and switch for Channel B, supporting transformer-balanced operation.
Receptacle for optional PL-2 line-balancing transformer for Channel B.
Inputs for electronic crossover and outputs for bi-amping.
Socket for optional PL-MODULE electronic crossovers.
Switches to select Stereo/Bridge mode and enable/defeat DDT compressor.
Guidelines for installing the amplifier in home or studio environments.
Explanation of bridge mode, its ratings, and usage with sound systems.
Schematic diagrams illustrating stereo and bridge mode connections.
Technical details including rated power, frequency response, and damping factor.
Details on Peavey's one-year limited warranty for the product.
Instructions for warranty registration and obtaining service.
Instructions on product placement, ventilation, and power supply connection.
Advice on when to seek qualified service and how to clean the unit.
Guidance on preventing hearing loss from high noise levels.
To Next Page
