Need help?Do you have a question about the Peavey CS 1200H and is the answer not in the manual?
Describes stereo dual-channel operation with independent controls.
Explains bridging channels for a single powerful mono amplifier.
Describes power switch, input attenuators, and amp function switches.
Explains status LEDs like Signal, DC, Temp, DDT, Active, and bar graphs.
Covers mode switch, DDT switch, amp function switches, and channel input.
Describes air intake and exhaust vents for thermal management.
Details output connectors, patch connectors, and AC line connector.
Describes crossover and low cut adjustment knobs and switches.
Explains DDT compression for maximizing performance and preventing clipping.
Describes Load Fault Correction for safe operation into any load.
Details how the amplifier protects itself from overheating.
Explains how the LFC circuit protects against output shorts.
Describes protection against DC voltage or subsonic frequencies at output terminals.
Explains the protection mode during power-up and power-down.
Step-by-step guide for setting up the amplifier in stereo mode.
Step-by-step guide for setting up the amplifier in bridged mono mode.
Guide for parallel operation using full range output.
Step-by-step guide for configuring the amplifier for bi-amplification.
To Next Page
General
