Need help?Do you have a question about the Peavey CS 800x4 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Number of Channels | 4 |
| 8 Ohms Bridged | 1600W |
| 4 Ohms Bridged | 2400W |
| Total Harmonic Distortion | < 0.1% |
| Signal to Noise Ratio | > 100 dB |
| Rack Units | 2 |
| 2 Ohms Stereo | 1200W |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 20 kΩ |
| 4 Ohms Stereo | 800W per channel |
Essential steps to take before powering up and during operation to ensure safety and prevent damage.
Instructions for bridging two channels to create a powerful monaural amplifier, with safety notes.
Covers protection against output shorts, DC voltage, turn-on/off transients, and load faults.
Explains thermal shutdown and DDT gain reduction to prevent overheating and clipping damage.
Procedures for obtaining service and details about the limited warranty coverage.
Explains what is covered and not covered by the Peavey limited warranty.
Instructions on how to get repair or replacement service under warranty.
To Next Page
