Need help?Do you have a question about the Peavey CS 400x and is the answer not in the manual?
Describes dual parallel input jacks for high impedance signals.
Details the conventional three-pin female XLR input jack.
Explains the switch for PL-2 transformer and input mode selection.
Location for optional PL-2 line-balancing transformer.
Details 1/4" jacks and binding posts for speaker connections.
Describes dual parallel input jacks, also with Y-cord capability.
Details the XLR input, which becomes QUASI-BALANCED or TRANSFORMER-BALANCED.
Explains the switch for PL-2 transformer and input mode selection for Channel B.
Location for optional PL-2 transformer for Channel B.
High Z inputs for electronic crossover module installation.
Receptacle for PL-MODULE ELECTRONIC CROSSOVER.
Supplies crossed-over low frequency output for biamp systems.
Supplies crossed-over high frequency output for biamp systems.
Same function and comments as channel A speaker outputs.
Selects STEREO or BRIDGE mode operation.
Enables or defeats the DDT compressor.
Protects the transformer from overheating and fault conditions.
Details connection requirements for the 120V power source.
Overview of amplifier installation and connection procedures.
Guidance for installing the amplifier in rack-mount configurations.
Recommendations for installing the amplifier in home or studio environments.
Key performance characteristics of the amplifier at 120V AC, 60 Hz.
Details typical output power ratings in stereo and bridge modes.
Specifies rated output power across different impedance and frequency ranges.
Defines the power bandwidth of the amplifier.
Indicates the slew rate for stereo and bridge modes.
Specifies the total harmonic distortion levels.
Details input sensitivity and impedance ratings.
Provides physical dimensions and weight of the amplifier.
Outlines the frequency response across different conditions.
States the damping factor of the amplifier.
Specifies the hum and noise levels.
Indicates the power consumption details.
Describes the amplifier's cooling system.
Details the switchable DDT compression system with LED.
Details the one-year limited warranty for the product.
Specifies the 90-day warranty for tubes and meters.
Outlines conditions, exclusions, and limitations of the warranties.
Provides instructions for completing and mailing the warranty registration card.
To Next Page
General
