65
GPS 3500 SPEZIFIKATIONEN
Nennleistung (2 x 4 Ohm): 1,200 Watts @ 1 kHz both channels driven at <0.1% T.H.D.
Nennleistung (2 x 8 Ohm): 775 Watts @ 1 kHz both channels driven at <0.1% T.H.D.
Brug Mode (2 x 8 Ohm): 2,400 Watts @ 1 kHz both channels driven at <0.1% T.H.D.
Maximaler RMS Spannungshub: 89 Volts
Frequenzgang: 10 Hz - 100 kHz; +0, -.3d B at 1 Watt
Leistungsbandbreite: 10 Hz - 40 kHz; +0, -3 dB at rated power
T.H.D. (2 x 4 ohms): <0.1% @ 1050W from 20 Hz to 20 kHz with both channels driven
T.H.D. (2 x 8 ohms): <0.08% @ 750W from 20 Hz to 20 kHz with both channels driven
Eingang CMRR: > - 65 dB @ 1 kHz
Spannungsverstärkung: x 40 (32 dB)
Übersprechen: > -75 dB @ 1 kHz at rated power @ 8 Ohms
Geräuschspannungsabstand: > -115 dB, “A” weighted referenced to rated power @ 8 Ohms
Leistungsverbrauch: > 1400 Watts
Anstiegsgeschwindigkeit: > 40V/us
Dämpfungsfaktor (8 Ohm): > 325:1 @ 20 Hz - 1 kHz
SMPTE IMD: <0.1% 60Hz and 7 kHz, 950 W @ 4 Ohms
Eingangsempfindlichkeit (x 40): 1.7 volts for 4 Ohm rated power, 1.4 volts for 2 Ohm rated power
Eingangsimpedanz: 20 k Ohms, balanced
Current Draw bei 1/8 Ausgangsnennleistung
an @ 4 Ohms: 11.66 A @ 120 Volts
Kühlung: Two 80 mm DC fans, off until heatsinks reach 45
˚ C, then temperature dependent variable speed
Regler: Two front panel attenuators
LED-Anzeigen: Two DDT/Clip, 2 Signal, 2 Power
Schutzfunktionen: Thermal, DC, turn-on bursts, subsonic, incorrect loads
Verbindungen: XLR input, 6.3 mm phone type output patch, Speakon and Binding Post speaker output, IEC
mains input
Bauart: 16 ga. steel reinforced with 12 ga.rack ears
Abmessungen: 133 mm x 483 mm x 432 mm, 400 mm behind rear mounting ears (5.23" x 19" x 17", 15.75" behind
rack ears)
Gewicht: 51.3 lbs. (23.3 kg)
Änderungen der technischen Daten vorbehalt
To Next Page
Loading...
