((2255)) HHIIGGHH OOUUTT
This 1/4" jack supplies the high frequency signal determined by the crossover frequency control and the
crossover balance control. Use this jack to route the signal to an external power amp or to the power amp input of
the MAX 700 when signal separation is desired. Use of this jack does not defeat the high
frequency signal going to the power amp section.
((2266)) SSTTAATTUUSS//PPOOWWEERR LLEEDD
The LED is green when the power switch is in the “on” position. During normal operation, the LED also acts as a
DDT indicator. The LED illuminates red when DDT power amp compression is taking place. When DDT is defeated,
the LED will illuminate red when clipping occurs.
7
To Next Page
Loading...
