To Next PageTo Next Page
Need help?Do you have a question about the Peavey Invective MH and is the answer not in the manual?
General| Number of Channels | 2 |
|---|---|
| Preamp Tubes | 3 x 12AX7 |
| Power Tubes | 2 x EL84 |
| EQ | 3-band |
| EQ Controls | Bass, Mid, Treble |
| Inputs | 1 x 1/4" (Instrument) |
| Effects Loop | Yes |
| MIDI I/O | No |
| Power Output | 20W |
| Outputs | 1 x 1/4" |
| Footswitch I/O | 1 x 1/4" |
| Features | Noise Gate |
| Speaker Output | 8 Ohms |
| Dimensions | 8.5" |
| USB | Yes (recording) |
Standard 1/4" jack for connection to the output of your guitar or last pedal if using effects before the amp.
Volume control for Clean channel and passive tone controls that regulate the low (bass) and high (treble) frequencies of the clean channel's tone.
Allows selection of the two different channels. The 'IN' position selects the 'LEAD' channel and 'OUT' selects the 'Clean' channel.
Activates the footswitchable preset input gate function when engaged. Used with Lead BOOST (6) for a more precise muting characteristic.
Activates the footswitchable TIGHT function. Reduces gain and alters EQ for a quasi-third channel for articulate, full sounding high gain.
Activates the footswitchable preset input boost function, similar to Misha's favorite TS style boost.
Controls the input volume level of the LEAD CHANNEL, affecting gain and overdrive.
Passive tone controls regulating low (bass), mid, and high (treble) frequencies for the Lead channel.
Controls the output level of the LEAD channel, used for volume and balancing sound between channels.
Adjusts damping factor of the power amplifier. Resonance affects low end, Presence affects high end response.
LEDs indicate output tube status (green for normal, red for fault). Monitor tube health and protection circuits.
Shuts amp off while leaving tube filaments on. Use for breaks and warm-up delay.
Applies power to the unit. Three of four front panel LEDs should illuminate indicating power supply.
Selects between two AC line/mains voltages. Should be set to the correct voltage for your country/territory.
Receptacle for IEC line cord providing AC power. Connect line cord here for unit power.
Located in fuseholder cap. Must be replaced with same type/value to avoid damage and warranty voidance.
Three-position attenuator switch for 100%, 25%, and 5% of rated power (20W, 5W, 1W).
Selects speaker/cabinet impedance between 16Ω or 8Ω. Set to half individual value for parallel enclosures.
Connects to an external speaker cabinet. Use a proper speaker cable, not a shielded instrument cable.
Disconnects speaker cabinet, redirects output to internal dummy load for silent practice/recording.
Connects to headphones via stereo mini-jack. Enables silent practice with filtered output.
Simulates microphone sound near loudspeaker cone for accurate signal to mixing console.
Engage to eliminate hum in MSDI™ output by removing ground loop. Leave 'out' (GRND) otherwise.
1/4" output jack supplying signal to external effects or processing equipment. Always active for sending preamp signal.
1/4" input jack for returning signals from external effects. Acts as a switching jack to break signal path from SEND.
Connects one or two Peavey 2-button Footswitches with LEDs. Controls channel selection, TIGHT, BOOST, GATE, and EFFECTS LOOP.
No drivers needed. Plug USB 2.0 cable to computer, detected as audio device for recording.
