Why does the Peavey PV 1015 D Speaker System sound heavily compressed?
The sound may seem heavily compressed because the DDT system indicator light is on. Check this indicator and reduce the control level of the mixing console or the level control of the PV 1015D speaker.
What to do if Peavey Speaker System amplifier saturates and lights up RED?
If the amplifier saturates and lights up red, reduce the output level of the mixing console and increase the level control on the PV 1015D speaker.
What to do if signal saturation occurs before reaching the Peavey PV 1015D Speaker System?
If signal saturation occurs before reaching the PV 1015D speaker, reduce the output level of the mixing console and increase the level control on the PV 1015D speaker.
Why does the Peavey PV 1015D Speaker System's effective sound level seem disappointing?
The effective sound level of the PV 1015D speaker may seem disappointing due to the absence of distortion or obvious signal degradation. Proceed with extreme caution when adjusting the maximum output volume.
How to prevent extremely unpleasant feedback with a Peavey PV 1015 D?
To prevent extremely unpleasant feedback, make sure to keep the microphone away from the front of the speaker when adjusting its level.
General| Power Handling (Program) | 500W |
|---|---|
| Woofer Size | 15" |
| Sensitivity | 98 dB |
| Nominal Impedance | 8 ohms |
| Nominal Coverage | 90° x 40° |
| Power Handling (Continuous/Peak) | 1000 Watts |
| Tweeter | 1.4" Titanium Diaphragm Compression Driver |
| Enclosure Material | Plywood |
| Grille | Steel with Foam Backing |
| Input Connectors | 2 x Speakon, 2 x 1/4" |
| Dimensions (H x W x D) | 14.5" |
| Type | Two-way passive loudspeaker |
To Next Page
