Peavey PV 8 - Page 12

Power Adapter Input
Use to connect the included power supply. Be sure the power supply is connected to the PV®8 before
connecting to a power source. Use 15 VDC, 0.5A adapter only.
Note: Replace only with Peavey part number 30901986 for Domestic or 30902780 for Export.
Power Switch
Depressing the power switch supplies power to the unit.
Tape In/Out
The tape input jacks are designed to accommodate tape‚ CD or computer sound card output levels. The
output level is +4 dBu for connection to a recorder or sound card input. The tape inputs can be used as
an additional stereo input by engaging the Tape/USB to Main Mix switch (14). The tape input can also be
used to monitor the recorder/sound card output without the risk of feedback.
USB port and USB Record Level Control (PV
®
8 USB only)
The USB port is used to connect the PV
®
Series USB mixer to acomputer for recording or playing back digital
audio to/from your computer. The USB port sends the mixer’s main/tape stereo out to the computer. The
amount of the main mix signal being sent to the USB port can be adjusted using the Record Level control
located next to the USB port. The USB port receives digital audio from the computer; it can then be assigned
through the “Tape/USB to Mix” switch (14) to the main left/right output. The USB input level is controlled by
the computer volume control.
Compatible with Windows
®
Vista, XP, ME & 2000. Also compatible with Mac OS X
®
10.0 or later.
12
Rear Panel
38
35
37
36
35
36
37
38
39
39