EasyManua.ls Logo

Peavey PV 8 - Page 15

Peavey PV 8
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
PV
®
8 Specifications
Frequency Response
Mic Input to Left/Right Output 14 Hz to 25 kHz +0 dB/-1 dB
Total Harmonic Distortion
<0.01% 20 Hz to 20 kHz Mic to Left/Right Output (10 Hz to 80 kHz BW)
<0.005% Typical (22 Hz to 22 kHz BW)
<0.0007% Mic Pre-amp Distortion
Hum and Noise
Output Residual Noise S/N Ratio (Ref: +4dBu) Test Conditions
Master Left/Right -98 dBu
-90 dBu
-84 dBu
102 dB
94 dB
90 dB
Master Fader Down, Channel Levels Down
Master Fader Nominal, Channel Levels Down
All controls nominal, mic gain minimum
Monitor Send -103 dBu
-84 dBu
107 dB
88 dB
All controls off
All channel sends nominal, masters nominal
Effects Sends -103 dBu
-84 dBu
107 dB
88 dB
All controls off
All channel sends nominal, masters nominal
(Hum and noise measurements: 22 Hz to 22 kHz BW)
Equivalent Input Noise (EIN)
-129 dBu (input terminated with 150 ohms)
Crosstalk/Attenuation
Adjacent Input Channels (1 kHz) >80 dB
Left to Right Outputs (1 kHz) >75 dB
Common Mode Rejection Ratio (Mic Input)
50 dB minimum (20 Hz to 20 kHz)
70 dB typical @ 1 kHz
Meters
6 segment, peak reading (0 db = +4 dBu)
Signal/Overload Indicators
Red LED lights 3 dB below clipping
Dimensions
9.32" wide x 11.625" deep x 2.76" high
(23.70cm x 29.5cm x 7.0cm)
Installation Note:
This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"
Weight
Power Requirements
Domestic: 15 VDC, 0.5A; 7.5 Watts
Without power supply: 5.7 lbs. (2.58 kg)
With power supply: 7.0 lbs. (3.17 kg)

Other manuals for Peavey PV 8

Related product manuals