Peavey Studio Chorus 210

BOTTOM (12)
An active tone control (shelving type ±15 dB) that varies the low frequency boost or cut.
NOTE: This control is not functional on the Normal channel.
BODY (13) ,
An active tone control (peak/notch, ±15 dB) that varies the mid frequency boost or cut.
NOTE: This control is not functional on the Normal channel.
EDGE (14)
An active tone control (shelving type, ±15 dB) that varies the high frequency boost or cut.
NOTE: This control is not functional on the Normal channel.
REVERB (15)
Controls the overall reverb level.
RATE CONTROL (16)
Controls the sweep rate (frequency) of the chorus effect.
DEPTH CONTROL (17)
Controls the depth (intensity) of the chorus effect.
POWER LED (18)
Illuminates when AC power is being supplied to the amp.
POWER SWITCH (19) . . . .
Depress the switch to the “On” position. The red pilot light (LED) will illuminate indicating power is being
supplied to the unit.
20
21
22
24 25
STUDIO ™
CHORUS ff ", (j) (•; ® m
210
MADE IN U.S.A.
23
GROUND SWITCH (20)
Three position rocker-type switch which, in most applications, should be operated in its center or zero posi¬
tion. There may be some situations when audible hum and/or noise will come from the loudspeaker. It this
situation arises, position the ground switch to either positive or negative ( + or -) or until the noise is minimized.
NOTE* Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or
a qualified service technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT
MODELS.
STEREO HEADPHONE JACK (21) ......
Provided for use with any stereo headset. One channel of the headphones will deliver signals processed by
the chorus circuit. The other side will deliver only “dry” (unprocessed) signals. Use of a monaural headset
is not recommended.