Peavey Studio Chorus 210

POWER AMP INPUT 1 & 2 (22)
Provides “insert” points to both internal power amps at their respective inputs. These jacks are the switching
type and “break” the signal chain at this point.
PREAMP OUT MIX (23)
The Preamp Output can be used to route the amplified signal to a mixing console, tape recorder, etc. connect
the Preamp Output, using a shielded cable, to an input of the tape recorder, mixer, outboard power amplifier,
etc. This patch does not affect the operation of the amplifier.
NOTE: When only the preamp out mix 2 jack is used, the mixed chorus effect is present at this point. (Com¬
bination of dry and chorused signals) When both preamp out jacks are engaged, only the chorused signal
appears at this point.
PREAMP OUT DRY (24)
The preamp output can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect
the preamp output, using a shielded cable, to an input of the tape recorder, mixer, outboard power amplifier,
etc. This patch does not affect the operation of the amplifier.
NOTE: The dry (unchorused) signal is always present at this point even when both preamp out jacks are
engaged. This jack should be used for normal preamp out patching when the chorus effect is not desired.
REMOTE FOOTSWITCH JACK (25)
Provided for the connection of the supplied remote footswitch. Footswitch is used to select the Lead or Nor¬
mal channels and defeat reverb and the chorus circuit.
LINE CORD (120V PRODUCTS ONLY) (26)
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not
advisable to remove the ground pin under any circumstances. If it is necessary to use the equipment without
proper grounding facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock
hazard exists when the unit is operated with the proper grounded receptacles.