Peavey Studio Pro 110

SPECIFICATIONS
POWER AMP SECTION
Rated Pi»wer Sc Load:
65 W RMS into S ohms
Power @ Clipping: (typically)
(5% I'HD. 1 kHz,
120 V AC line)
65 W RMS into 8 ohms
4 ohms not recommended
Frequency Response;
-1-0. -2 dB. 20 Hz 10 10 kHz
50 W into 8 ohms
Total Hai*monic Distortion:
Less than 0.2%. lOO mW co
50 W RMS. 60 Hz 10 10 kHz.
8 ohms (typically below 0.l®/o)
Hum & Noise:
Greater than 78 dB below the
rated power
Power Consumption:
200 W. .50/60 Hz, 120 V AC
PRE.AMP SECTION
ThP specs art measured # 2 kHz
with the controls pruiel as fnitow^;
Push Bright Off COul)
Channel Select Normal (Out)
I.ow' & High © 10
Mid @ 0
SuperSai^ & Post Gain @ 10
Pull gain Off (In)
Bonom, Body. & Edge © 0 dB
Nominal levels ai*e with
normal gain @ S
Minim II m levels are whh
normal gain © 10
Preamp High Cain Input:
(inpedance: High 7. 220 K ohm^
Noinimil Input Level; -16 dBV.
150 mV RMS
Minimum Input Level: -34 dBV.
20 inV RMS
Maximum InpiU Level: +16 dBV.
6 V RMS
Preamp I-ow Gain Input;
(10 dB pad)
Impedance: High 7. 60 K ohms
Nominal Input Level: -6 dBV
450 mV RMS
Minimum Input Level: -24 dBV.
60 mV RMS
Maximum Input Level:
+26 JBV, 18 V RMS
BLOCK DIAGRAM
Effects Return:
Impedance: High Z, 22 K ohms
Designed Input l.cvel: -10 dBV,
0.3 V RMS
(Switching jack providing Effects
Send to Effects Return connec¬
tion when not u.scd)
System Hum & Noise
© Nominal Input Level:
(20 Hz to 20 kHz unweighted)
74 dB below rated power
Equulizalioii:
(Normal Channel Only)
Special Low. Mid, & High
passive type EQ
Push bright: +6 dB @2 kHz
Voicing:
Special Bottom. B(xiy, & Edge
active type EQ
Pull Gain; Increases
SuperSat'^ gain
External Footswitch Function:
Reverb Defeat (when reverb con¬
trol is raised)
Lead Channel Defeat (when
selected aith buuon)
LEAD
SUP£li GAIN POST
t>#P
VOICING
m p'J®”
CHANNiL
NORMAL
vunn im m In «n*r M
•k<df Bm ¥•»>