Rated Power
&
Load:
Power specs measured with
T. Dynamics
@
10%
100 W RMS into 16, 8, or
4 ohms
Power
@
Clipping: (typically)
(5% THD, 1
kHz,
120 V AC line)
100
W RMS into 16, 8, or
4 ohms
Frequency Response:
+O,
3
dB,
60 Hz to 20
kHz,
@80WRMS
Hum
&
Noise:
Greater than 86
dB
below rated
power
Power Consumption:
Domestic: 300 W
@
60 Hz,
120 VAC
Export: 300 W
@
50/60 Hz,
220-230/240 V AC
PREAMP SECTION
The following specs are measured
@
I kHz with the controls preset as follows:
Push Bright, Off (out)
Channel Select Normal (out)
Low&
High
@
10
Mid
63
0
Presence
@
0 dB
Pre
&
Post Gain
@
10
Gain
&
Thrash, Off (out)
Normal Levels are with normal volume
625
Minimum Levels are with normal
volume
@
IO
SPECIFICATIONS
Preamp High Gain Input:
Impedance: High-Z, 1 M ohm
Nominal Input Level: -14
dBV,
200
mV
RMS
Minimum Input Level: -24
dBV,
60
mV
RMS
Maximum Input Level: 0
dBV,
1 VRMS
Preamp Low Gain Input:
Impedance: High-Z, 44 K ohms
Nominal Input Level: -8
dBV,
400
mV
RMS
Minimum Input Level: -18
dBV,
120
mV
RMS
Maximum Input Level: 6
dBV,
2VRMS
Effects Send:
Load Impedance: 1 K ohm or
greater
Nominal Output Level: -10
dBV,
0.3 V RMS or 0
dBV,
1 V RMS
if Effects Level is in
Effects Return:
Impedance: High-Z, 22 K ohms
Designed Input Level: -10
dBV,
0.3 V RMS or 0
dBV,
1 V RMS
if Effects Level is in
(Switching jack provides Effects Send to
Effects Return connection when not used)
Preamp Output:
Load Impedance: 1 K ohm or
greater
Nominal Output Level: 0
dBV,
1 VRMS
Power Amp Input:
Impedance: High-Z, 30 K ohms
Designed Input Level: 0
dBV,
1 VRMS
(Switching jack provides preamp output to
power amp input connection when not
used)
System Hum
&
Noise
@
Nominal Input Level:
(20
Hz to 20 kHz
un
weigh ted)
72
dB
below rated power
Equalization:
Special low, mid,
&
high passive
type
EQ
Presence:
+6
dB
@
5
kHz
Push Bright:
+6
dB
@
2
kHz
Push Thrash: -20 dB notch
@
1
kHz
in Lead channel
Push Gain: Increases Lead gain
Push Resonance:
+6
dB
@
cabinet resonance
External Footswitch Functions:
Lead Channel Defeat (when
selected with button)
Effects Loop Bypass
Dimensions
&
Weight:
10.25” H x 24.375” W x
11.25”
D
35.7 Ibs.
A
Due to our
eforts
for constant improvements,
features and specl$cations listed herein are subject to change without notice.
To Next Page
Loading...
