CHANNELS
Your TransTube Series amp offers two-channel operation. Both the Clean and Lead channels
provide a flexible platform for you to establish your favorite tone. The footswitch (optional on Envoy
110 and Studio Pro 112) allows remote switching between the two channels and is explained in
detail on page 8 of this guide.
6. Channel Select Switch
The Channel Select Switch determines which channel of the TransTube Preamp, LEAD or
CLEAN, is active. This switch must be in the “LEAD” position in order for the footswitch
function of your amp to work.
CLEAN CHANNEL
7. Volume
This control sets the volume level for the Clean channel. It is best to start with the control
fully counterclockwise (minimum gain) and adjust clockwise until the desired level is
achieved. After all EQ and voicing adjustments have been made to the channel, you may
wish to reset this control.
8. Modern/Vintage Switch
This switch allows you to instantly change the voicing to reflect the tones of modern and
vintage amplifiers. The MODERN position maintains a warm, standard voicing. The VINTAGE
5
6
7 8 9
To Next Page
Loading...
Need help?
General
