Peavey Triumph PAG 60 - Page 4

PRE GAIN (11)
Controls the input volume level of the channel.
POST GAIN H2)
Controls the overall volume level of the channel. The final level adjustment should be made after the desired
sound has been achieved.
BOTTOM (13) u t
An active tone control (shelving type ±15 dB) that varies the low frequency boost or cut.
NOTE: This control is not functional on the Clean channel.
BODY (14) , ,
An active tone control (peak/notch, ±15dB) that varies the mid frequency boost or cut.
NOTE: This control is not fuctional on the Clean channel.
EDGE (15)
An active"tone control (shelving type, ±15 dB) that varies the high frequency boost or cut.
NOTE: This control is not functional on the Clean channel.
REVERB LEVEL (16) r . , „ ,
Reverberation is an echo effect. Rotate clockwise to increase the effect. Remote tootswitch can control On/Oft.
Contto^die^weraU vohlme level of the system. Once a desired balance of the Clean Crunch and Ultra chan¬
nels is achieved, the entire system level may be increased or decreased with the Master Level Co
STATUS LED (18) . . .
Illuminates when amp is switched to standby indicating amplifier is not operational
POWER LED (19)
Illuminates when AC power is being supplied to the amp.
STANDBY SWITCH (20)
Allows amp to be placed in standby or active
is not operational.
mode. In standby mode the tubes remain hot, but the amplifier
POWER SWITCH (21)
Depress the switch to the “On” position. The red pilot light (LED)
supplied to the unit.
will illuminate indicating power is being