Peavey Triumph PAG 60 - Page 5

BACK PANEL
Ik Ik
CAUTION
RISK Oh t-LK TRIC SHOCK
DO NO i OPEN
AVIS: RISQUE DE CHOC
ELECTRQUE - NE PAS OUVRIR.
EFFECTS PREAMP SPEAKER OUTPUTS
120 VAC SEND RETURN OUT REMOTE SWITCH
60 Hz 60 W RMS/22 V RMS
200 WATTS
Ik Ik
CAUTION
RISK OF flFCTRiC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR.
EFFECTS PREAMP
SPEAKER OUTPUTS
120 VAC SEND RET URN OUT REMOTE SWITCH
6°Hz III I
200 WATTS III I
120 W RMf/31 V RMS
22 28 23 24 25 26 27
GROUND SWITCH (22)
Three position rocker-type switch which, in most applications, should be operated in its center or zero posi¬
tion. There may be some situations when audible hum and/or noise will come from the loudspeaker. If this
situation arises, position the ground switch to either positive or negative ( + or -) or until the noise is minimized.
NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or
a qualified service technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT
MODELS.
EFFECTS SEND (23)
Output for supplying signals to external effects or signal processing equipment.
EFFECTS RETURN (24)
Input for returning signals from external low-level effects or signal processing equipment.
PREAMP OUT (25)
The preamp output can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect
the preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not
affect the operation of the amplifier.
FOOTSWITCH JACK (26)
Provided for the connection of the supplied remote footswitch. Footswitch switch is used to select the Ultra
Gain, Crunch Gain, or Normal channels and defeat reverb.
SPEAKER OUTPUTS (27)
Speaker output (14 ") jacks are provided for main and auxiliary, Main jack is 8 ohms impedance and auxiliary
jack is 4 ohms. When both jacks are engaged, amplifier impedance is 4 ohms.
LINE CORD (120V PRODUCTS ONLY) (28)
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not
advisable to remove the ground pin under any circumstances. If it is necessary to use the equipment without
proper grounding facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock
hazard exists when the unit is operated with the proper grounded receptacles.