Pg. 10 Pg. 11
5. Make sure the seat is tight enough so that you can’t twist
it out of alignment. Pull the seat clamp handle away from
the seat post and slide the seat up or down to adjust it.
Move the clamp handle inward toward the seat post so it is
held tight by the clamp.
If necessary, tighten the clamp by twisting the clamp handle
clockwise while in the unclamped position. Then, fold the
handle in toward the seat post. This should require a fair
amount of force to ensure the seat post is held tight. If
necessary, the clamp can be further tightened with a 5 mm
allen wrench while in the clamped position. Make sure the
seat is not set with the vertical maximum height marks above the clamp.
6. Using the 15 mm wrench provided in the tool kit, attach
and tighten the pedals. PLEASE NOTE – The pedals are
marked “L” for Left and “R” for Right. The left pedal is at-
tached by turning it counterclockwise and the right pedal
is tightened by turning it clockwise. Make sure the pedals
are tightly attached to the crank arms to prevent stripping.
If the disc brakes are rubbing after installation, refer to Customer Help on our web-
site at www.pedegoelectricbikes.com/faqs/customerhelp/
For ALL Pedego Models
Item Nm
Handlebars 18N.m (Trail Tracker 12N.m)
Handlebar Stem 12N.m (Trail Tracker 8N.m)
Seatpost Quick Release
Seat 18N.m
Front Wheel 18N.m (If Applicable)
Rear Wheel 30N.m or above
Torque Specifications
To Next Page
Loading...
Need help?
General
