Pedigo P-2010 - Page 2

Pedigo P-2010, P-2020, P-2030, P-2040, P-2050, P-2055 Blanket Warming Cabinets Operation and Care Manual
1
UNPACKING AND SET-UP
Transport and Storage Environmental Conditions (not to exceed 15 days)
• Ambient temperature range of -40° to +159°F (-40° to +70°C)
• Relative humidity range of 10% to 100%, including condensation
• Atmospheric pressure range of 50KPa to 106KPa
BLANKET WARMING CABINET
DELIVERY
The Pedigo Warming Cabinet has been thoroughly
tested and inspected to insure only the highest
quality unit is provided. Upon receipt, check for
any possible shipping damage and report it at
once to the delivering carrier. See
Transportation Damage and Claims section
located in this manual.
This appliance, complete with unattached items
and accessories, may have been delivered in one
or more packages. Check to ensure that all
standard items and options have been received
with each model as ordered.
Save all the information and instructions packed
with the appliance. Complete and return the
warranty card to the factory as soon as possible
to assure prompt service in the event of a
warranty parts and labor claim.
This manual must be read and understood by all
people using or installing the equipment model.
Contact the Pedigo service department if you
have any questions concerning installation,
operation, or maintenance.
NOTE: All claims for warranty must include the
full model number and serial number of
the unit.
UNPACKING
1. Carefully remove the
appliance from the carton
or crate.
NOTE: Do not discard the
carton and other
packaging material
until you have
inspected the unit
for hidden damage
and tested it for
proper operation.
2. Read all instructions in this manual carefully
before initiating the installation of this
appliance.
DO NOT DISCARD THIS MANUAL.
This manual is considered to be part of the
appliance and is to be provided to the owner
or manager of the business or to the person
responsible for training operators.
Additional manuals are available from the
Pedigo service department.
3. Remove all protective plastic film, packaging
materials, and accessories from the appliance
before connecting electrical power.
TRANSPORT AND STORAGE