Pedigo P-2010 - Safety Procedures and Precautions

Pedigo P-2010, P-2020, P-2030, P-2040, P-2050, P-2055 Blanket Warming Cabinets Operation and Care Manual
2
SAFETY PROCEDURES AND PRECAUTIONS
Knowledge of proper procedures is essential to
the safe operation of electrically and/or gas
energized equipment. In accordance with
generally accepted product safety labeling
guidelines for potential hazards, the following
signal words and symbols
may be used throughout this manual.
Used to indicate the
presence of a hazard that
will cause severe personal
injury, death, or substantial
property damage if the
warning included with this
symbol is ignored.
Used to indicate the
presence of a hazard that
can cause personal injury,
possible death, or major
property damage if the
warning included with this
symbol is ignored.
Used to indicate the
presence of a hazard that
can or will cause minor or
moderate personal injury
or property damage if the
warning included with this
symbol is ignored.
Used to indicate the
presence of a hazard that
can or will cause minor
personal injury, property
damage, or a potential
unsafe practice if the
warning included with this
symbol is ignored.
Used to notify personnel of
installation, operation, or
maintenance information
that is important but not
hazard related.
1. Pedigo blanket warmers are intended for
warming cotton blankets ONLY. No other use
for this device is authorized or recommended.
Pedigo fluid warmers are ONLY intended
for warming medical solutions for irrigation
and injection. The IRRIGATION MODE should
be selected for warming irrigation fluids, and
the INJECTION MODE should be selected for
warming injection fluids. Please refer to the
labeling of the manufacturer of the products
to be warmed regarding the recommended
temperature and the duration of warming. No
other use for this device is authorized or
recommended.
2. This device is intended for use in commercial
establishments where all operators are
familiar with the purpose, limitations, and
associated hazards of this device. Operating
instructions and warnings must be read and
understood by
all operators and users.
3. Any troubleshooting guides, component views,
and parts lists included in this manual are for
general reference only and are intended for use
by qualified technical personnel.
4. This manual should be considered a
permanent part of this device. This manual
and all supplied instructions, diagrams,
schematics, parts lists, notices, and labels must
remain with the device
if the item is sold or moved to another
location.
NOTE:
Enthermics warmers should not be left unattended for
periods of more than 24 hours. In case of absences
longer than 24 hours, disconnect the warmer from its
power source.
Pedigo warmers should not be left unattended for
periods of more than 24 hours. In case of absences
longer than 24 hours, disconnect the wamrer from
its power source.