To Next Page
B
bryan32Aug 9, 2025
What to do if Pedigo Warming Drawer shows E-60 Real-Time Clock Checksum Error?
- CChristina DonovanAug 9, 2025
If your Pedigo Warming Drawer displays an E-60 error, it might be because the unit was unplugged for a while. Try this: turn the circuit breaker switch to the ON position for 1 minute, then turn it OFF for 5 seconds, and back to ON. The error message should disappear. After resetting, leave the unit plugged in with the circuit breaker ON for at least 24 hours to fully recharge. Also, verify that the date and time are correct.
General
