3
REQUIREMENTS FOR PRESSURE TESTING
(ANSI Z223.1 - 1984)
1. The oven and its individual shut off valve must be disconnected from the
gas supply piping system during any pressure testing of that system at
test pressures in excess of 1/2” psig (3.45KPA).
2. The oven must be isolated from the gas supply piping system by closing
its individual manual shut off valve during any pressure testing at the gas
supply piping system at test pressures equal to or less than 1/2” psig
(3.45KPA).
WARNING
For an appliance equipped with casters, instructions that
(1) shall be made with a connector that complies with the
Standard for Connectors for Movable Gas Appliances,
ANSI Z21.69 - CSA 6.16, and a quick disconnect device
that complies with the Standard for Quick Disconnect
Devices for use with Gas Fuel, ANSI Z31.41 - CSA 6.9,
(2) adequate means must be provided to limit the movement
of the appliance without depending on the connector and
the quick disconnect device or its associated piping to
limit the appliance movement and
(3) the location(s) where the restraining means may be
To Next Page
Loading...
