CW SERIES PARTS REPLACEMENT INSTRUCTIONS
THERMOSTAT
steel lower door, which is fastened by two small
caution in removing capillary tube and wire. To
replace, reverse procedure.
SAFETY PILOT
out.
BURNER Remove transite shelves and oven bottom. Unbolt
pilot from cross arm. Lift burners up at rear of
front.
REPLACE DOOR Plates are fastened to door frame. Remove
HINGE PINS screws and move door forward enough to slide
hinge pin clear of frame. Insert new pin and put
back into position. Drill new holes for screws to
refasten.
COUNTER-BALANCED With door in closed position, open S/S lower
WEIGHTS door. Weights are visible, including cap screws
that hold them in place. Remove screws releasing
weights from door arms. Remove hinge pins as
described above and door can be removed from
oven.
TO CHANGE Contact Factory
GAS TYPES
16
To Next Page
Loading...
